Health check and panel clean
Plenty of systems quietly underperform for years because nobody is watching them. We compare what your system has been making with what a system that size should make in Melbourne, read the inverter's fault log, and look over the isolators, cabling and mounting. Then we clean the panels with soft brushes and plain water. You get a short written report with photos, so you never need to go on the roof yourself.
What is included
- Generation compared with an estimate for your system size and roof
- Inverter fault log and settings checked
- Rooftop isolators, cabling and mounting inspected for wear and water damage
- Panels cleaned with soft brushes and plain water, no harsh chemicals
- Written report with photos of anything we found
- A fixed price in writing for any repair before it is done
Signs you need this
- Your power bill has gone up and nothing else in the house has changed
- The inverter shows a red or orange light, or an error code
- The app shows much less on a clear day than it used to
- The system is more than five years old and has never been checked
- Panels sit under trees or near a busy road and look dirty from the ground
How we do it
Find out if your system is making what it should, and get the panels cleaned properly.
- 01
Tell us what you have
System size, inverter brand and roughly when it was installed. A photo of the inverter label helps.
- 02
Check and clean
We test the system, inspect the roof gear safely with the right equipment, and clean the panels. Allow about two hours.
- 03
Report
You get the findings in writing with photos, and a price for any repair worth doing.
Find out what your roof could make
Send a recent power bill and your address. You get an honest estimate and a fixed price, and no one turns up to pressure you.